• <tr id='HoPour'><strong id='HoPour'></strong><small id='HoPour'></small><button id='HoPour'></button><li id='HoPour'><noscript id='HoPour'><big id='HoPour'></big><dt id='HoPour'></dt></noscript></li></tr><ol id='HoPour'><option id='HoPour'><table id='HoPour'><blockquote id='HoPour'><tbody id='HoPour'></tbody></blockquote></table></option></ol><u id='HoPour'></u><kbd id='HoPour'><kbd id='HoPour'></kbd></kbd>

    <code id='HoPour'><strong id='HoPour'></strong></code>

    <fieldset id='HoPour'></fieldset>
          <span id='HoPour'></span>

              <ins id='HoPour'></ins>
              <acronym id='HoPour'><em id='HoPour'></em><td id='HoPour'><div id='HoPour'></div></td></acronym><address id='HoPour'><big id='HoPour'><big id='HoPour'></big><legend id='HoPour'></legend></big></address>

              <i id='HoPour'><div id='HoPour'><ins id='HoPour'></ins></div></i>
              <i id='HoPour'></i>
            1. <dl id='HoPour'></dl>
              1. <blockquote id='HoPour'><q id='HoPour'><noscript id='HoPour'></noscript><dt id='HoPour'></dt></q></blockquote><noframes id='HoPour'><i id='HoPour'></i>

                机①动车燃料的硫♀ 标准查询●与下载



                共找到 1 条与 机动需要换车了车燃料的硫 相关的标放心吧准,共 1

                This test method can be used to determine total sulfur levels in process feeds and finished products that fall within the scope of this test method. Low levels of sulfur in process feed stocks can poison expensive catalysts used in petroleum refining processes. This test method can be used to monitor sulfur levels in these feedstocks. 1.1 This test method covers the determination of total sulfur in liquid hydrocarbons with a final boiling point less than 450x00B0;C by gas chromatography using a flame photometric detector. 1.2 This test method is applicable for total sulfur levels from 0.5 to 100 mg S/kg. Note 18212;The pooled limit of quantification (PLOQ) derived from the 2002 interlaboratory cooperative test program was determined to be 1 mgS/kg. Note 28212;Samples can also be tested at other total sulfur levels, but the precision statements may not apply. 1.3 The values stated in SI units are to be regarded as standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements see Section 7.

                Standard Test Method for Determination of Total Sulfur in Light Hydrocarbons, Motor Fuels, and Oils by Online Gas Chromatography with Flame Photometric Detection

                ICS
                75.160.20 (Liquid fuels)
                CCS
                E31
                发布
                2004
                实施



                Copyright ?2007-2016 ANTPEDIA, All Rights Reserved
                京ICP备07018254号 京公网♂安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号